Forum - Topic


X350 Key fob replacement


Forum XJ-X350 X350 Key fob replacement

Manuals  |  Advert  |  Model Jaguar XJ-X350  |  Our vehicles



e34e36  
2017-04-03 11:06:06

DIY: Jaguar Key Fob Battery Replacement  |  More info

Video tutorial on how to replace the battery and remove the buttons on a Jaguar key fob. This key fob is found between the years 1999 to 2009 for both the X-Type and S-Type vehicles. The disassembly includes how to open the case, remove the battery, circuit board, and buttons.

Website:

Facebook:

Google Plus:

Twitter:

Instagram:

Tumblr:

Pintrest:

Tools/Supplies Needed:

  • small standard/flat screwdriver
  • phillips screwdriver
  • lithium battery model number CR2032

Procedure:

  • separate the case in half using a standard screwdriver
  • there is a small cutout on the backside of the key fog, then the buttons and key portion will separate
  • using a standard screwdriver again, split the button portion open
  • once you have the circuit board exposed, remove the small phillips screw using a screwdriver
  • slide out the circuit board and a battery will be exposed underneath
  • a standard screwdriver can be used to remove it
  • a replacement battery is a lithium battery model number CR2032
  • installed the new battery with the positive side downwards facing the rear of the case
  • as for the rubber bottom pad, that can be removed by pushing the buttons inward, then grabbing the rear and pulling out
  • installation in reverse

Programming or pairing a new remote Key fob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Key fob battery has been allowed to go flat, or the car battery has been removed for any length of time.

Follow these steps exactly and you should have no problems, pairing old or replacement Key fobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries.

2.)Get in the car and close the drivers side door.

3.)Put the key into the ignition and turn to position I.

4.)Wait 5 seconds

5.)Turn the key quickly to position II then back to I four times. (do this only once)

6.)You should hear a single chime.

7.)Remove the Key

8.)For each Key fob in rapid succession. Press any single button on the key fob you wish to pair, you should hear a chime as each Key fob is paired with the security system. After the chime press a button on the next Key fob you wish to pair.

9.)On completion after all keys have been programmed, wait 3 minutes then check the operation of each Key fob by locking/unlocking the vehicle.

Note : All the fobs that you wish to use must be paired at the same time. Every time you operate the key as in step 5 above the code will be changed, previously programmed fobs will no longer work unless you pair them all at the same time.

Thank you to all those who watch my videos and support my content. Don't forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week!

© 4DIYers 2013

All Rights Reserved

No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.


Reply